This project will meet the expectations for Objectives 4 and 5 This program is simple. This program will show how the motor are rotating. The goal of this project/program/circuit it to control the speed of the motor by using PWM- Pulse-Width-Modulation. With this program we should be able to put the maximum speed of the motor and reduce the speed to it minimum by controlling the speed. By using the potentiometer, we change the speed of the motor knowing that 1023 is its capacity. By increasing or decreasing the potentiometer we have the control of the speed/rpms of each motor. In this case both motors are going into the same direction since they are connected to the same PWM on the L293 microcontroller.
0 Comments
This project will meet the expectations for Objectives 1, 4 and 5 During this lab I want to show that Atmel Studio 7 is working as a source of coding programming for my Arduino UNO. The Arduino will have a USBasp connected to its board, and we will use this programmer to upload the code into the Arduino. We will have set up in the controller a command prompt which will the Avrdude. This lab consists of using a LCD screen and DHT11 temperature Humidity sensor to read the temp and humidity on the room or wherever you or the sensor/circuit is. |
|